Copy-pasting module settings

[kangirigungi]

If I copy-paste a building, it will copy its module settings too, which is fine. However, if I want to change the module settings, I cannot just copy-paste it. Is there any way to just bulk change the settings so that construction robots will change the modules? Upgrade planner doesn't work because that can change all X type of module to Y type, but it cannot add new modules, or, say, replace 2 X types of modules to one X and one Y type. But my main concern is adding modules, for example after replacing type 2 assembly machines to type 3 and new module slots are introduced, or if I forget to put modules on a bunch of machines to begin with.

[Fel]

If you just want to add blueprints, copy/paste or blueprint with the additional blueprints should work fine.

If you need to remove existing modules on the other hand, the quickest is to deconstruct the machines (with a deconstruction planner that is set to only mark the machines and nothing else) before setting a blueprint of it again (either without modules or with the modules you want).

[brian_va]

Module inserter mod if you're open to mods.