controllers?

[Scrubz94]

can a controller get a bearing to spin a saw blade fast enough to cut trees down? or do i need to still connect a motor for the blades im using 5 on my rig so i aws hoping to be able to use a controller to get them all spinning an or does it not work like that still a noob XD

[Elon Tusk]

Personally I have 2 drill heads on bearings connected to an electric engine and use a switch to turn them on when I need them, I have the engine upgraded a few times cause it's far slower than a gasoline engine.

[The Big Brzezinski]

Sure, though you may have to double up on bearings depending on your upgrade level. You go bearing, block, bearing, saw, spin the bearings the same direction.

[Phishfood]

I've tested it and you need about 5 bearings with a fully upgraded controller on the fastest speed.

Best just use an engine.

[The Big Brzezinski]

Originally posted by Phishfood:

I've tested it and you need about 5 bearings with a fully upgraded controller on the fastest speed.

Best just use an engine.

Really? I ran two saws off a level three controller just fine. Drills worked as well.

[Scrubz94]

I have mine to lvl 4 I think and the Sam things still go like 1 mph