Assign cells to specific security prisoners

[Mazamune]

Ok so i have been playing prison architect for a lil while now but i still haven't found out how to assign specific cells to specific security prisoners.

Let met explain a bit my case. I have built hight quality cells and some lower quality ones in my game. Up to that, it's all good. Now i want to put medium security prisoners to the lower quality cells and minimum security prisoners to the higher quality cells.

Is it possible to do that ? And if so, how ???

Cause i have been messing around, trying to figure this out and up now, to no avail. I tried to put location assignement (with the assignment tool) for min ou med security prisoners only to both emplacements but when i do that, my lower security prisoners ends up in general holding cells ...

[Deadpan Serious]

if those cells are in cellblock, then you can only assign a Deployment setting to the entire block.

you'll have to segment the cellblock. open doors can do that.

[CloudSeeker]

If you have a cellblock for min sec you can't then have med sec prisoners living in those. To do that you have to manually move 1 prisoner to low sec from med sec because only shared cellblocks can have mixed security stats.

[Münster Mike]

You can just install a door somewhere in your cell block to make the different areas capable of being separately designated to a different security levels. Essentially making two smaller cell blocks from one big one by installing a door.

[Mazamune]

ok, thanks, i'll try this and see if it does the trick