Laser just wont work

[nathan3219]

I'm trying to hit a building with GBU-38 and GBU-12. I set target on the TGP as my SPI and the laser switch is armed. I check the profiles to make sure that they are CCRP, Auto Lase ON, laser 15 seconds, and drop them from from about 15,000 feet. My TGP gets the flashing L for laser but the bombs dont seem to react. When I press F6 to watch them fall it's like they aren't even reacting to the laser. Do i not have the proper "Laser codes" set? Help..

[Sandy]

Did you select the weapons in the DSMS page using DMS? If you simply pick them using the OSB buttons, they won't use your profiles.

[Nirvi]

GBU-38 are GPS guided, you don't need a laser. 15 seconds lasing time is pretty long if you drop a GBU-12 from 15000 ft. Try 12 seconds.

[Sandy]

Also also, by default the laser codes should match but it's possible for a mission designer to change it.

[Rvotri]

Probably you turned laser on before load the pod.
Also you don't need laser on GBU-38, but you might use it to mark target and have a more precise shoot

Turn Laser off and on on Switch in Weapons panels... Also Turn TGP off and on too. Time is no problem, i use 20 seconds in any height launch

[nathan3219]

My bombs are working fine now, and that was the only time that has ever happened to me, so I would assume that I must of FUBAR'ed something along the way, lol. It might have had to do with Latch not being on.. but I'm not sure. Thanks for the replies all.

[Cannibal Holiday]

You have to say PEW PEW when you use them.