On controller, when i use the triggers for throttle it instantly goes fully down

[Fullsend]

On yt iv seen videos how to get fast of the line starts, but on those videos they go half throttle untill its green lights, how do i achieve that on controller? I try not to go all the way on the trigger but nonetheless it goes full rpm

[Maya-Neko]

You simply press the trigger only halfway through. If you've problems with that, then you could also try to use a higher linearity, so that the first part of the way is less sensitive.

And well, once the tyres loose grip, they won't give any resistance anymore to the engine, which is why it goes full RPM. That's why you've to switch to 2nd gear asap after starting and sometimes even 3rd gear, if the tyres won't stop spinning even in 2nd.

And for an optimal start also make sure, that the tyres are hot enough, otherwise they might loose grip faster.

[Fullsend]

Thank you for your reply. I did try to go halfway with the triggers, but it instantly goes full rpm, What linearity do you recommend?

[Maya-Neko]

i personally use 0 linearity since i don't have any problems with it due to the amount of training i've put into it. So i can't really say anything about how it works in particular.

[Fullsend]

I'll give the linearity a shot tomorrow I think it's at 0 atm

[VaNessa#37 | WCL]

First and formost what controller are you using???????
I used a ps4 and a ps5 controller (both work well and i pretty much use vanilla settings)

I just turn the sensitivity steering on 115 instead of 100 but thats personal preference.

[oris2810]

I use a Xbox controller and have set my throttle linearity to 30 it seems to be the perfect sweet spot for me personally, try fiddling with that setting it should help. Also make sure to have assists off and Race starts setting to Manual.

[Fullsend]

I managed to get a dualsense working, much better now. I turned off steam input and now i had the option to conf my dualsense instead of a xbox controller