Stuck in Growpod D1

[Purp]

I'm having trouble starting the power in the last grow pod. I've tried moving the tube connected to the power module to separate connections but to no avail. I looks like you need both tubes to connect to the H20 and 02 connections respectfully but it seems you can't interact with the disconnected tube laid to the side. Am I missing something?

[Cahalith]

If you're in the grow pod I'm thinking of (the one where you can't reach the crops, right?), you don't need both tubes to be connected. Think about what the tube that's already in place is connected to.

Some hints:
The tube is connected to the sprinkler system that's used to water the plants, right?
Maybe you could use that system to your advantage?

Flat-out solution: Detach the tube from the H2O position and connect it to the O2 position, then......use the terminal to activate the sprinkler system. Afterwards......use the terminal to activate the power and then......jump in the water ASAP.

[Team Fortune Dev]

Imsim puzzles require point-and-click solutions.

[TowerNumberNine]

I had some trouble with this one because the ability to connect the tube to the other socket was not clear at all interface-wise, so I tried to do it and it seemingly didn't work -- even after reading this and seeing for sure that that was what to do I had to try quite a bit to get the connection in place.

[Team Fortune Dev]

The Assistant call not triggering properly in this zone has finally been fixed! You can now call the Assistant to get some instructions about the puzzle.

[Naberius]

Really fun puzzle, though it took me a while to understand that what I was doing was correct : upon turning the power, everything explores immediately.
Maybe the puzzle would make more sense if it gave you a 3-5 seconds countdown.

[Hero]

Needed to use this thread to figure out the solution. Maybe there is something I'm missing, why would pumping Oxygen through the sprinklers cause a fire? I didn't see any obvious open flames that would cause the explosion.

[Naberius]

Pure oxygen is extremely volatile, any spark, light, wire, etc would be enough to cause a combustion

[dariusd1st]

Thanks for this thread! Finally got through this puzzle hahaha :(

[Cripta putrida]

but what is the command to change the state of the sprinklers in Growpod D1

[Cahalith]

Originally posted by Cripta putrida:

but what is the command to change the state of the sprinklers in Growpod D1

You can usually use the help command to get a list of usable commands for the terminal you're on.

help

I think you should be able to switch states for the sprinklers with the commands

sprinklerctl enable

or

sprinklerctl disable