Wheel Calibration issues

[R.J MacReady]

When calibrating the wheel axis a message states "Multiple inputs detected..." thus preventing the calibration to continue. Fanatec DD2

[Saxohare]

Publicado originalmente por R.J MacReady:

When calibrating the wheel axis a message states "Multiple inputs detected..." thus preventing the calibration to continue. Fanatec DD2

did you try this?

I had problems assigning my SimuCube.
I reduced the rotation to a little value, I believe I choose 120 degrees in the driver.
I choose assign steering, but did no assigning but immediately left the game,
And restarted the game and assigned my axis.
Then I returned my steering wheel to 900 degrees
and calibrated it

[R.J MacReady]

It's fixed and thanks.

[Mahjik]

Publicado originalmente por R.J MacReady:

It's fixed and thanks.

Might post what you did to help if someone else runs into the same issue.

[R.J MacReady]

Publicado originalmente por Mahjik:

Publicado originalmente por R.J MacReady:

It's fixed and thanks.

Might post what you did to help if someone else runs into the same issue.

Thanks man and I thought I fixed it but still struggling. I'm back to square one bro.

[Quinnman88]

Could be way off base here but I've experienced this also on my T300 and turned out it had a problem with my Xbox one controller connected via wireless. removed the USB receiver and it was good to go From there. Keep in mind whilst troubleshooting, that keyboards, mice and other such things are considered to be inputs as well. Sounds to me that it's probably within the USB pipeline. Based on the nature of the problem "inputs", that's where I would start looking by removing all USB devices that I don't need and go from there. Check your USB power settings as well as system power settings also. Good Luck, these type things can be a nightmare,

[R.J MacReady]

After reinstalling several times I somehow got it to work.
1. Set wheel rotation to 120 degrees in FanaLab (drivers).
2. Open AMS2, options, controls, and select custom wheel.
3. Exit game then restart again. Go back to Controls and assign Left Right axis, all pedals and gears.
4. Reset you rotation to whatever you like. I set mine to Auto.
5. Calibrate wheel and pedal.
This is what I did to finally fix this annoying issue and I hope this helps.