Transport Fever 2

Transport Fever 2

Ver estadísticas:
Alguy 12 DIC 2019 a las 1:58 p. m.
Stuck on Chapter II Mission 10
I got to the point where I needed to create a line to bus around the press for 5 minutes, so i did so. The line is created correctly(Checked off), but I put a bus on the line and the game refuses to check off that a vehicle is enroute. Anyone have a solution to this? It's preventing me from progressing the campaign.
< >
Mostrando 16-29 de 29 comentarios
Huperspace 13 DIC 2019 a las 1:10 a. m. 
you need 2 newly build bus stations near the 2 points and then only the bus travel time from airport to press building is counted.
Tankfriend 13 DIC 2019 a las 10:52 a. m. 
Publicado originalmente por Warlord:
Delete all other Bus on other Routes this Mission is without Bug you dont need to cheat like Tankfried....i think this game is to heavy for him then.
Yeah sure. Learn the difference between "a game is too difficult" and "there is a single task that's too annoying but blocks all progress".
Diedel 13 DIC 2019 a las 11:00 a. m. 
It also seems to only work if there is only ONE bus on the route.
TheR3ALVinc 13 DIC 2019 a las 3:37 p. m. 
Where can I add waypoints? I just found them for trains...
FWSWBN 13 DIC 2019 a las 4:07 p. m. 
this works now eays....

1. create line from airport to the hotel
2. let 1 bus drive ... after the first round time counts.
3. stop bus, set some waypoints and edit the line
4. start bus and he drives the new line and the times counts.
5. done :-)


needs a while that i figure this out.
Cellfire 14 DIC 2019 a las 6:50 a. m. 
how do you add waypoints?
canophone 14 DIC 2019 a las 6:52 a. m. 
Publicado originalmente por Cellfire:
how do you add waypoints?

It's one of the options under the Streets menu, first selecting the icon above the streets in the menu.
Huperspace 14 DIC 2019 a las 6:53 a. m. 
Publicado originalmente por Cellfire:
how do you add waypoints?
a building type (click on waypoint icon). and only have to add them to the line.
RCRider 15 DIC 2019 a las 3:50 a. m. 
I did this and it works for me. Create line with 2 stops, wait until someone get on the bus and the countdown begins, then I change the line by adding way points. Hope this help.
chnewent 25 ENE 2020 a las 9:38 a. m. 
I just stopped all buses on BOTH routes from airport to premier and watched clock time up to 300 with success!!
CreatorOfWorlds 27 MAY 2020 a las 11:27 a. m. 
I finally did the mission by tricking to line.
First i established to line with only two stops by the air port and hotel to have the passengers see it as a short route, and having lots of busses on the line.
When finally there was a passenger (trapped) on board a bus, i edited the route and added a lot of way points to the route to make sure that it would be at least 300 sek.
It seems the route i cached by the bus initially, so after adding the way points, it was necessery to make the bus turn around via the vehicle window and then turn it around again, which made the bus follow all the newly added way points.
Sin317 27 MAY 2020 a las 11:33 p. m. 
You can just force stop the bus and wait out the timer. It's stupid but it works :)
parramattaambulancefinance 29 MAY 2020 a las 12:25 a. m. 
Each Block Stop vehicle up to 100 seconds , so near the end go over the 300 seconds
Gaspar 8 OCT 2021 a las 8:16 a. m. 
A tip to anyone who's stuck on this:

Delete every bus line close to the airport and close to the venue.
Delete the road from the airport to the venue.
Build a road(or a huge bridge over the city) all the way to Santa Barbara.
Place a waypoint on the Santa Barbara Airport.
Make a line - LA Airport>Waypoint in Santa Barbara>Venue.
Wait
?
Profit.
< >
Mostrando 16-29 de 29 comentarios
Por página: 1530 50

Publicado el: 12 DIC 2019 a las 1:58 p. m.
Mensajes: 29