Crosshair missing in scope

[Fallster]

Hi, I've tried everything, I've seen many suggestions how to fix this problem but none worked. Before you ask: yes I do meet more than enough of minimum requirements for this game to run. I tried render distance, changing details and graphics options and so on. Nothing helped me. What I dont understand is that I have this issue only inside story mission during campaing. In shooting range, I can see my scope perfectly fine. Any suggestions or tips would be appriciated.
tyty

[hotmatrixx]

you mean the black crosshair of the scope itself,when ADS'd in FPS / sniper mode, right?
Damn it I've seen someone talk about this before and I cannot remember what the fix was.

[MechBFP]

Originally posted by hotmatrixx:

you mean the black crosshair of the scope itself,when ADS'd in FPS / sniper mode, right?
Damn it I've seen someone talk about this before and I cannot remember what the fix was.

They don’t meet the minimum requirements for VRAM.

[stburr91]

Originally posted by MechBFP:

Originally posted by hotmatrixx:

you mean the black crosshair of the scope itself,when ADS'd in FPS / sniper mode, right?
Damn it I've seen someone talk about this before and I cannot remember what the fix was.

They don’t meet the minimum requirements for VRAM.

Yes, the op didn't say what gpu they had.

[dav]

It absolutely does not matter what GPU you have. I personally had to INCREASE fidelity on a high-end card to see the crosshair. There is no "proper" workaround outside of fiddling with Vulkan/DX12 and fidelity settings, some combination will work.

[postmaster]

What therefore is the solution.
Where do we look to make changes?

[hotmatrixx]

Originally posted by postmaster:

What therefore is the solution.
Where do we look to make changes?

Start by turning your graphics settings all the way up, see if it renders in. Make sure Vulkan is running from the pre-loader (ima just go check if I can do that RQ)

[hotmatrixx]

Originally posted by hotmatrixx:

Originally posted by postmaster:

What therefore is the solution.
Where do we look to make changes?

Start by turning your graphics settings all the way up, see if it renders in. Make sure Vulkan is running from the pre-loader (ima just go check if I can do that RQ)

Yeah so my important stuff is that
(it's the COG next to PLAY)

Resolution is set to Native (1920x1080) for me
Fullscreen Borderless Windowed, Dx12 enabled, and I have custom settings, but crank everything to ULTRA and see if it works, even if your frame rate tanks... we are just testing here... then if so great we can work backwards.

If not, switch to Vulkan, try again.

I suspect that making sure you're on YOUR native monitor resolution is going to be important here.

[ChickenTacos]

You could draw a crosshair on a piece of clear tape and stick said tape right in the center of your display.

[hotmatrixx]

Originally posted by ChickenTacos:

You could draw a crosshair on a piece of clear tape and stick said tape right in the center of your display.

lol
HUDSight.

[AngelKiller]

Problem still exists. crosshairs on pistol but not on rifles. Fix your game

[RadarLuv]

Originally posted by Fallster:

Hi, I've tried everything, I've seen many suggestions how to fix this problem but none worked. Before you ask: yes I do meet more than enough of minimum requirements for this game to run. I tried render distance, changing details and graphics options and so on. Nothing helped me. What I dont understand is that I have this issue only inside story mission during campaing. In shooting range, I can see my scope perfectly fine. Any suggestions or tips would be appriciated.
tyty

Even if you meet the requirements your graphics/resolution might be set to high that will affect it, try turning them down and see if that helps.