Subscribe to download
Saturn V (Apollo Mission)

Creator: rEtRo_sPexX
Channel: https://www.youtube.com/rEtRo_sPeXX-
Mods Required: None

This has been a very big (Literally!!) project to get my Apollo mission, Saturn V rocket on to the workshop.

It has taken a lot of fiddling around with, a few logic gates, a ton more full size thrusters (Not the mini, modded ones this time!!) hours of tweaking and the use of Durf's material converter tool to eliminate all unwanted Grego blocks (I couldn't find 3 of them, would you believe it?), to make this thing work in vanilla for everyone to try out, I hope it was worth it!!

You may have already seen this on my YouTube channel, if not then why not go and check it out, along with some of my other builds?

It is a frame killer due to it's massive proportions, but follow the guide bellow for the best results...

VERY IMPORTANT INSTRUCTIONS!!

1.) Spawn creation on a landing pad....(Needs a lot of room!)

2.) Place a single block on the landing pad and weld one of the boarding platform's legs to that block. (Reduces lag!)

3.) Use the toilet jump technique to climb up to the boarding ramp.

4.) Remove all florescent green blocks from the rocket, on each side of the bridge. (Two blocks on the left and a whole rod of blocks on the right) it will not take off without following this step!!

5.) You are now ready to board the Saturn V by using the switch on the door.

6.) Once inside press the button on the boarding ramp to lower it down; out of harms way.

7.) Close the door with the inside button.

8.) Take a seat at the middle pilot station.

9.) Press 1 to engage primary engines.

10 .) Press 2 for additional secondary engines. (Lift off shall commence at this point!)

11.) At a safe height, press 3 to disengage primary thrust and release the bottom (Fuel) section.

Happy blast off!!!

It will reach the wolrd's ceiling in little time and it doesn't do anything else, but it has to be my most popular creation so far and I thought it was time to add it to the workshop!!

Enjoy!!

Visit my YouTube Channel for more Scrap Mechanic Creations and Tutorials.

If you showcase or publish this creation then please credit me (rEtRo_sPexX) as the creator and add a link to my YouTube channel at:

https://www.youtube.com/rEtRo_sPeXX-