I cannot get the press to activate by clicking on the handle regardless of which stencil I'm using on it, not even the correct ones, which I'm assuming are:

the one with a dot in the lower-left quadrant and three lines on the left side (1 vertical, 2 horizontal) that make 2 right angles;

the one with a dot in the upper-left quadrant, two lines (one horizontal and one diagonal) that meet at a 135-degree angle, and a short vertical line on the lower-right side;

and the one with 2 lines that make a right angle in the upper-right corner, and two lines that make a 45-degree angle in the lower-right corner.

Is that detailed enough?

Originally posted by Brian Kuhn:

I cannot get the press to activate by clicking on the handle regardless of which stencil I'm using on it, not even the correct ones, which I'm assuming are:

the one with a dot in the lower-left quadrant and three lines on the left side (1 vertical, 2 horizontal) that make 2 right angles;

the one with a dot in the upper-left quadrant, two lines (one horizontal and one diagonal) that meet at a 135-degree angle, and a short vertical line on the lower-right side;

and the one with 2 lines that make a right angle in the upper-right corner, and two lines that make a 45-degree angle in the lower-right corner.

Is that detailed enough?

Those are the correct stencils you listed, are you putting them in the correct place on the printing press? the slots for them are on the left side of the machine.

I just tried it again. I didn't realize before that all 3 stencils had to be (or even could be) placed in the machine to get it to work. Sorry.

Glad I could help 👍

I can get two stencils in place but not matter where i move the mouse, the third won't slot in?

if you try to use the keys on the door, they will fall and they won't land, they will fall out of the map and I don't think you can get them back

We took the word wheels out of the padlock using phrases and they fell out. We couldn't put them back in and they were invisible so we couldn't complete that.