Dawn of War II: Retribution - How to Adjust Gameplay Speed

[Vorebait]

Hi everyone, I spent some time looking around trying to figure out if anyone had done this, but it looks like that wasn't the case. I did, however, see that a few people were asking about this a while back and I wanted to share how to do that since I just figured it out after some messing around.

1. From Steam, right-click on Warhammer 40,000: Dawn of War II - Retribution and select Properties (Fig 1).

http://steamcommunity.com/sharedfiles/filedetails/?id=1292989467
Fig 1


2. In the window labelled Warhammer 40,000: Dawn of War II - Retribution - Properties, for the tab laballed GENERAL, click on SET LAUNCH OPTIONS... (Fig 2).

http://steamcommunity.com/sharedfiles/filedetails/?id=1292989697
Fig 2


3. In the new window labelled Launch Options - Warhammer 40,000: Dawn of War II - Retri..., (1) type: -dev and then (2) click OK. (Fig 3)

http://steamcommunity.com/sharedfiles/filedetails/?id=1292989988
Fig 3


4. Launch Warhammer 40,000: Dawn of War II - Retribution.

5. Once you are in-game, either begin your current campaign, load your current save game, etc.

6. After you are finished loading and are actively playing, press the tilde key (`) on your keyboard. This will open the in-game console.

7. In the console, type: Game_SetSimRate () (Fig 4).

http://steamcommunity.com/sharedfiles/filedetails/?id=1292990279
Fig 4


Note: A space is required between Game_SetSimRate and (). Also, you have to enter a number in-between (). I don't know what the default rate is, but from what I understand I think its in seconds. Either way, play around with it as you see fit.

[ZaidusRecon]

Good guide. In fact, I advise you copy and paste this into an actual guide and publish it in the Guides tab of this community hub ;)