Source Filmmaker > 综合讨论 > 主题详情
Bread 2013年9月3日下午6:28
Unlocked Lock
I locked a Scattergun to a Scout but all it does is shake up and down when I make him run. I'm 99.99% sure I locked it correcty. You drag the weapon_bone of the Scout to the weapon_bone of the Scattergun, right? I did that and like I said, it just sakes up and down. I try other locking something to an Engineer and it worked, however.
最后由 Bread 编辑于; 2013年9月3日下午7:12
正在显示第 1 - 6 条,共 6 条留言
< >
raptornx01 2013年9月3日下午7:00 
you just drag the whole model. click on the scout, drag him to the gun. then slide the zero preset and that should bring them together.
Bread 2013年9月3日下午7:12 
引用自 raptornx01
you just drag the whole model. click on the scout, drag him to the gun. then slide the zero preset and that should bring them together.
That didn't work. Any other ideas?
最后由 Bread 编辑于; 2013年9月3日下午7:12
R234 2013年9月3日下午7:21 
Is the gun's animation set selected when you drag the zero slider? Also, are you in motion editor mode?
Bread 2013年9月3日下午7:23 
引用自 R234
Is the gun's animation set selected when you drag the zero slider? Also, are you in motion editor mode?
No, and yes.
mlisty2 2013年9月3日下午9:22 
Lock the rootTransform and the weapon_bone of the gun to the weapon_bone of the scout.
Select both the rootTransform and the weapon_bone of the gun.
Switch to motion editor and drag the zero preset all the way to move the gun to the weapon_bone of the hand.
R234 2013年9月3日下午9:32 
引用自 R234
Is the gun's animation set selected when you drag the zero slider? Also, are you in motion editor mode?
No, and yes.
Well there's your problem. The gun needs to be selected.
正在显示第 1 - 6 条,共 6 条留言
< >
每页显示数: 15 30 50
发帖日期: 2013年9月3日下午6:28
帖子数: 6