Source Filmmaker > Algemene discussies > Details van topic
Ferexes 19 jun 2013 om 10:31nm
Messed up timeline
My timeline recently had a bug where instead of 1 second increments, there are hundred centiseconds or whatever increments, and it becomes impossible to even time a particle correctly without taking up like 30 minutes...
1-6 van 6 reacties weergegeven
< >
Pte Jack 20 jun 2013 om 12:05vm 
Hover your mouse over the time line... Hold down the shift key and roll your center mouse button, that will increase and decrease the time elements of the time line...
Ferexes 20 jun 2013 om 8:08vm 
No, I meant that the playhead goes through the 100th second mark within 3 seconds.
R234 20 jun 2013 om 2:55nm 
Can we have a screenshot of your timeline, in clip editor mode?
raptornx01 20 jun 2013 om 10:25nm 
whats the frame rate?

it's supposed to go by frame. each tick of the playhead being one frame. so the higher the framerate the more ticks it takes to go through a second of film. and vice versa
Ferexes 20 jun 2013 om 10:51nm 

It seems that the normal 1, 2 ,3 is replaced with 100, 200, 300.
Pte Jack 20 jun 2013 om 11:03nm 
Doh, right click on the 100, 200, 300 and change the time code display back to Timecode:Seconds
1-6 van 6 reacties weergegeven
< >
Per pagina: 15 30 50
Geplaatst op: 19 jun 2013 om 10:31nm
Aantal berichten: 6