Source Filmmaker > Общи дискусии > Подробности за темата
Android Engie#3 22 януари в 6:50след.
SFM partical problems.
Ok i just found out how to use particals. And i made one work. I say ONE for a reason. When i tried to make another partical for the same clip, it wouldnt show up. The scene was supposed to have two unusual hats in it, but none of the unusual particals are showing up after i added the first. Help plz.
Показване на 1-6 от 6 коментара
< >
Pte Jack is away for a MONTH 22 януари в 7:21след. 
I love these questions,... It's like:

Hey everyone, I'm outside.. can someone tell me where I am and give me directions to the nearest pub???

DETAILS Bonk, what particles are you using from which pcf file? what map are you using to display them in? Are they locked to a model, which one and what bone. When do you have start and for what life time?
Android Engie#3 23 януари в 4:58след. 
Heh sorry bout that. Im using the "item_fx.pcf file". The map is 2fort. It's not locked to the model yet. and i have start time at zero. and lifetime for the entire clip. Like i said above it was supposed to show two unusual hat effects but only one is showing up on the playback. Again sorry for the lack of details. if this is still not enough I will give more info.
R234 23 януари в 5:13след. 
Did you move the playhead off of the active clip and back?
Android Engie#3 23 януари в 7:29след. 
No. I didn't think of that. I didn't feel like it would have any effect.
Pte Jack is away for a MONTH 23 януари в 7:35след. 
Yup, very important step... Everytime you add a new particle, move the playhead off the clip and then back on again. It initializes the particle system.
Последно редактиран от Pte Jack is away for a MONTH; 23 януари в 8:21след.
Android Engie#3 23 януари в 7:56след. 
ugh i feel so stupid. That was all i needed to do. thanks for the help.
Показване на 1-6 от 6 коментара
< >
На страница: 15 30 50
Дата на публикуване: 22 януари в 6:50след.
Публикации: 6